src/drivers: Fix typo

Change-Id: I9144937b72a98517cbd41c093cff7bad543b4140
Signed-off-by: Elyes HAOUAS <ehaouas@noos.fr>
Reviewed-on: https://review.coreboot.org/27916
Reviewed-by: Martin Roth <martinroth@google.com>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>

src/drivers/amd/agesa/def_callouts.c

@@ -91,7 +91,7 @@ AGESA_STATUS agesa_Reset (UINT32 Func, UINTN Data, VOID *ConfigPtr)
 
 	//
 	// Perform the RESET based upon the ResetType. In case of
-	// WARM_RESET_WHENVER and COLD_RESET_WHENEVER, the request will go to
+	// WARM_RESET_WHENEVER and COLD_RESET_WHENEVER, the request will go to
 	// AmdResetManager. During the critical condition, where reset is required
 	// immediately, the reset will be invoked directly by writing 0x04 to port
 	// 0xCF9 (Reset Port).

src/drivers/elog/elog.c

@@ -670,7 +670,7 @@ static int elog_find_flash(void)
 	}
 
 	if (region_device_sz(rdev) < 4*KiB) {
-		printk(BIOS_WARNING, "ELOG: Needs a minium size of 4KiB: %zu\n",
+		printk(BIOS_WARNING, "ELOG: Needs a minimum size of 4KiB: %zu\n",
 			region_device_sz(rdev));
 		return -1;
 	}

src/drivers/i2c/designware/dw_i2c.c

@@ -360,7 +360,7 @@ static int _dw_i2c_transfer(unsigned int bus, const struct i2c_msg *segments,
 	}
 
 	/* The assumption is that the host controller is disabled -- either
-	   after running this function or from performing the intialization
+	   after running this function or from performing the initialization
 	   sequence in dw_i2c_init(). */
 
 	/* Set target slave address */

src/drivers/i2c/generic/chip.h

@@ -35,7 +35,7 @@ struct drivers_i2c_generic_config {
 	struct acpi_gpio irq_gpio;
 
 	/*
-	 * This flag will add a device propery which will indicate
+	 * This flag will add a device property which will indicate
 	 * to the OS that it should probe this device before adding it.
 	 *
 	 * This can be used to declare a device that may not exist on

src/drivers/i2c/ww_ring/ww_ring.c

@@ -74,7 +74,7 @@
 #define LP55231_RESET_VALUE	0xff
 
 /*
- * The controller has 192 bytes of SRAM for code/data, availabe as six 32 byte
+ * The controller has 192 bytes of SRAM for code/data, available as six 32 byte
  * pages.
  */
 #define LP55231_PROG_PAGE_SIZE  32
@@ -119,7 +119,7 @@ static int ledc_transfer(TiLp55231 *ledc, struct i2c_msg *segs,
 	while (max_attempts--) {
 		rv = i2c_transfer(ledc->i2c_bus, segs, seg_count);
 
-		/* Accessing reset regsiter is expected to fail. */
+		/* Accessing reset register is expected to fail. */
 		if (!rv || reset)
 			break;
 	}

src/drivers/intel/fsp1_1/romstage.c

@@ -128,7 +128,7 @@ void romstage_common(struct romstage_params *params)
 			params->pei_data->saved_data_size =
 				region_device_sz(&rdev);
 			params->pei_data->saved_data = rdev_mmap_full(&rdev);
-			/* Assum boot device is memory mapped. */
+			/* Assume boot device is memory mapped. */
 			assert(IS_ENABLED(CONFIG_BOOT_DEVICE_MEMORY_MAPPED));
 		} else if (params->pei_data->boot_mode == ACPI_S3) {
 			/* Waking from S3 and no cache. */

src/drivers/intel/fsp2_0/debug.c

@@ -36,7 +36,7 @@ void fsp_debug_before_memory_init(fsp_memory_init_fn memory_init,
 	if (IS_ENABLED(CONFIG_DISPLAY_UPD_DATA))
 		fspm_display_upd_values(fspm_old_upd, fspm_new_upd);
 
-	/* Display the call entry point and paramters */
+	/* Display the call entry point and parameters */
 	if (!IS_ENABLED(CONFIG_DISPLAY_FSP_CALLS_AND_STATUS))
 		return;
 	printk(BIOS_SPEW, "Calling FspMemoryInit: 0x%p\n", memory_init);

src/drivers/intel/fsp2_0/include/fsp/api.h

@@ -107,7 +107,7 @@ void soc_update_memory_params_for_mma(FSP_M_CONFIG *memory_cfg,
  *
  * This function is responsible for loading and executing the notify code from
  * the FSP-S binary. It expects that fsp_silicon_init() has already been called
- * succesfully, and that the FSP-S binary is still loaded into memory.
+ * successfully, and that the FSP-S binary is still loaded into memory.
  */
 
 #endif /* _FSP2_0_API_H_ */

src/drivers/intel/gma/i915_reg.h

@@ -609,7 +609,7 @@
 #define LM_FIFO_WATERMARK   0x0000001F
 #define MI_ARB_STATE	0x020e4 /* 915+ only */
 
-/* Make render/texture TLB fetches lower priorty than associated data
+/* Make render/texture TLB fetches lower priority than associated data
  *   fetches. This is not turned on by default
  */
 #define   MI_ARB_RENDER_TLB_LOW_PRIORITY	(1 << 15)
@@ -1636,9 +1636,9 @@
 #define   BLM_PIPE_C			(2 << 29) /* ivb + */
 #define   BLM_PIPE(pipe)		((pipe) << 29)
 #define   BLM_POLARITY_I965		(1 << 28) /* gen4 only */
-#define   BLM_PHASE_IN_INTERUPT_STATUS	(1 << 26)
+#define   BLM_PHASE_IN_INTERRUPT_STATUS	(1 << 26)
 #define   BLM_PHASE_IN_ENABLE		(1 << 25)
-#define   BLM_PHASE_IN_INTERUPT_ENABL	(1 << 24)
+#define   BLM_PHASE_IN_INTERRUPT_ENABL	(1 << 24)
 #define   BLM_PHASE_IN_TIME_BASE_SHIFT	(16)
 #define   BLM_PHASE_IN_TIME_BASE_MASK	(0xff << 16)
 #define   BLM_PHASE_IN_COUNT_SHIFT	(8)

src/drivers/intel/gma/opregion.c

@@ -318,7 +318,7 @@ intel_gma_init_igd_opregion(igd_opregion_t *opregion)
 	opregion->header.size = sizeof(igd_opregion_t) / 1024;
 
 	/*
-	 * Left-shift version field to accomodate Intel Windows driver quirk
+	 * Left-shift version field to accommodate Intel Windows driver quirk
 	 * when not using a VBIOS.
 	 * Required for Legacy boot + NGI, UEFI + NGI, and UEFI + GOP driver.
 	 *

src/drivers/maxim/max77802/max77802.h

@@ -227,7 +227,7 @@ enum {
 
 /*
  * MAX77802_REG_PMIC_BBAT set to
- * Back up batery charger on and
+ * Back up battery charger on and
  * limit voltage setting to 3.5v
  */
 #define MAX77802_BBCHOSTEN	(1 << 0)

src/drivers/net/chip.h

@@ -19,7 +19,7 @@ struct drivers_net_config {
 	unsigned wake;	/* Wake pin for ACPI _PRW */
 	/*
 	 * There maybe many NIC cards in a system.
-	 * This paramter is for driver to identify what
+	 * This parameter is for driver to identify what
 	 * the device number is and the valid range is [1-10].
 	 */
 	uint8_t device_index;

src/drivers/pc80/tpm/tis.c

@@ -743,7 +743,7 @@ static int tis_setup_interrupt(int vector, int polarity)
 	/* Set TPM interrupt vector */
 	tpm_write_int_vector(vector, locality);
 
-	/* Set TPM interupt polarity and disable interrupts */
+	/* Set TPM interrupt polarity and disable interrupts */
 	tpm_write_int_polarity(polarity, locality);
 
 	/* Close connection if it was opened */

src/drivers/ti/tps65913/tps65913rtc.c

@@ -29,7 +29,7 @@ enum TPS65913_RTC_REG {
 	TPS65913_WEEKS_REG		= 0x06,
 	TPS65913_RTC_CTRL_REG		= 0x10,
 	TPS65913_RTC_STATUS_REG	= 0x11,
-	TPS65913_RTC_INTERRUPS_REG	= 0x12,
+	TPS65913_RTC_INTERRUPTS_REG	= 0x12,
 };
 
 enum {

src/drivers/xgi/common/vb_setmode.c

@@ -958,7 +958,7 @@ static void XGI_SetCRT1FIFO(struct xgi_hw_device_info *HwDeviceExtension,
 
 	data = xgifb_reg_get(pVBInfo->P3c4, 0x3D);
 	data &= 0xfe;
-	xgifb_reg_set(pVBInfo->P3c4, 0x3D, data); /* diable auto-threshold */
+	xgifb_reg_set(pVBInfo->P3c4, 0x3D, data); /* disable auto-threshold */
 
 	xgifb_reg_set(pVBInfo->P3c4, 0x08, 0x34);
 	data = xgifb_reg_get(pVBInfo->P3c4, 0x09);