Split out enter_conf_mode_*()/exit_conf_mode_() functions, we'll soon need
them. Reduce code duplication a bit by improved 'no dump available' handling. Signed-off-by: Uwe Hermann <uwe@hermann-uwe.de> Acked-by: Uwe Hermann <uwe@hermann-uwe.de> git-svn-id: svn://svn.coreboot.org/coreboot/trunk@2785 2b7e53f0-3cfb-0310-b3e9-8179ed1497e1
This commit is contained in:
parent
c73ea4d4fc
commit
25a6c0f18c
|
@ -89,15 +89,26 @@ void dump_fintek(uint16_t port, uint16_t did)
|
|||
regval(port, 0xf6), regval(port, 0xf7), regval(port, 0xf8));
|
||||
}
|
||||
|
||||
void probe_idregs_fintek(uint16_t port)
|
||||
void enter_conf_mode_fintek(uint16_t port)
|
||||
{
|
||||
uint16_t vid, did, success = 0;
|
||||
|
||||
/* Enable configuration sequence (Fintek uses this for example)
|
||||
* Older ITE chips have the same enable sequence.
|
||||
*/
|
||||
outb(0x87, port);
|
||||
outb(0x87, port);
|
||||
}
|
||||
|
||||
void exit_conf_mode_fintek(uint16_t port)
|
||||
{
|
||||
/* Exit MB PnP mode (for Fintek, doesn't hurt ITE). */
|
||||
outb(0xaa, port);
|
||||
}
|
||||
|
||||
void probe_idregs_fintek(uint16_t port)
|
||||
{
|
||||
uint16_t vid, did, success = 0;
|
||||
|
||||
enter_conf_mode_fintek(port);
|
||||
|
||||
outb(0x20, port);
|
||||
if (inb(port) != 0x20) {
|
||||
|
@ -143,7 +154,6 @@ void probe_idregs_fintek(uint16_t port)
|
|||
if (!success)
|
||||
printf("No dump for vid 0x%04x, did 0x%04x\n", vid, did);
|
||||
|
||||
/* Exit MB PnP mode (for Fintek, doesn't hurt ITE). */
|
||||
outb(0xaa, port);
|
||||
exit_conf_mode_fintek(port);
|
||||
}
|
||||
|
||||
|
|
|
@ -211,10 +211,8 @@ void dump_ite(uint16_t port, uint16_t id)
|
|||
}
|
||||
}
|
||||
|
||||
void probe_idregs_ite(uint16_t port)
|
||||
void enter_conf_mode_ite(uint16_t port)
|
||||
{
|
||||
uint16_t id, chipver;
|
||||
|
||||
/* Enable configuration sequence (ITE uses this for newer IT87[012]x)
|
||||
* IT871[01] uses 0x87, 0x87 -> fintek detection should handle it
|
||||
* IT8708 uses 0x87, 0x87 -> fintek detection should handle it
|
||||
|
@ -230,6 +228,18 @@ void probe_idregs_ite(uint16_t port)
|
|||
outb(0x55, port);
|
||||
else
|
||||
outb(0xAA, port);
|
||||
}
|
||||
|
||||
void exit_conf_mode_ite(uint16_t port)
|
||||
{
|
||||
regwrite(port, 0x02, 0x02);
|
||||
}
|
||||
|
||||
void probe_idregs_ite(uint16_t port)
|
||||
{
|
||||
uint16_t id, chipver;
|
||||
|
||||
enter_conf_mode_ite(port);
|
||||
|
||||
/* Read Chip ID Byte 1. */
|
||||
id = regval(port, 0x20);
|
||||
|
@ -252,20 +262,8 @@ void probe_idregs_ite(uint16_t port)
|
|||
printf("Super I/O found at 0x%02x: id=0x%04x, chipver=0x%01x\n",
|
||||
port, id, chipver);
|
||||
|
||||
switch (id) {
|
||||
case 0x8702:
|
||||
case 0x8705:
|
||||
case 0x8708:
|
||||
case 0x8712:
|
||||
case 0x8716:
|
||||
case 0x8718:
|
||||
case 0x8726:
|
||||
dump_ite(port, id);
|
||||
break;
|
||||
default:
|
||||
printf("No dump for ID 0x%04x\n", id);
|
||||
break;
|
||||
}
|
||||
regwrite(port, 0x02, 0x02); /* Exit MB PnP mode. */
|
||||
dump_ite(port, id);
|
||||
|
||||
exit_conf_mode_ite(port);
|
||||
}
|
||||
|
||||
|
|
|
@ -40,6 +40,16 @@ const static struct superio_registers reg_table[] = {
|
|||
{EOT}
|
||||
};
|
||||
|
||||
void enter_conf_mode_smsc(uint16_t port)
|
||||
{
|
||||
outb(0x55, port);
|
||||
}
|
||||
|
||||
void exit_conf_mode_smsc(uint16_t port)
|
||||
{
|
||||
outb(0xaa, port);
|
||||
}
|
||||
|
||||
/* Note: The actual SMSC ID is 16 bits, but we must pass 32 bits here. */
|
||||
void dump_smsc(uint16_t port, uint16_t id)
|
||||
{
|
||||
|
@ -57,7 +67,7 @@ void probe_idregs_smsc(uint16_t port)
|
|||
{
|
||||
uint16_t id, rev;
|
||||
|
||||
outb(0x55, port); /* Enter configuration mode. */
|
||||
enter_conf_mode_smsc(port);
|
||||
|
||||
/* Read device ID. */
|
||||
id = regval(port, DEVICE_ID_REG);
|
||||
|
@ -75,15 +85,8 @@ void probe_idregs_smsc(uint16_t port)
|
|||
printf("Super I/O found at 0x%04x: id=0x%02x, rev=0x%02x\n",
|
||||
port, id, rev);
|
||||
|
||||
switch (id) {
|
||||
case 0x28:
|
||||
dump_smsc(port, id);
|
||||
break;
|
||||
default:
|
||||
printf("No dump for ID 0x%04x\n", id);
|
||||
break;
|
||||
}
|
||||
dump_smsc(port, id );
|
||||
|
||||
outb(0xaa, port); /* Exit configuration mode. */
|
||||
exit_conf_mode_smsc(port);
|
||||
}
|
||||
|
||||
|
|
|
@ -34,14 +34,12 @@ void regwrite(uint16_t port, uint8_t reg, uint8_t val)
|
|||
outb(val, port + 1);
|
||||
}
|
||||
|
||||
void dump_superio(const char *name, const struct superio_registers reg_table[],
|
||||
void dump_superio(const char *vendor, const struct superio_registers reg_table[],
|
||||
uint16_t port, uint16_t id)
|
||||
{
|
||||
int i, j, k;
|
||||
int i, j, k, nodump;
|
||||
int *idx;
|
||||
|
||||
printf("%s ", name);
|
||||
|
||||
for (i = 0; /* Nothing */; i++) {
|
||||
if (reg_table[i].superio_id == EOT)
|
||||
break;
|
||||
|
@ -49,12 +47,15 @@ void dump_superio(const char *name, const struct superio_registers reg_table[],
|
|||
if ((uint16_t)reg_table[i].superio_id != id)
|
||||
continue;
|
||||
|
||||
printf("%s\n", reg_table[i].name);
|
||||
nodump = 1;
|
||||
|
||||
for (j = 0; /* Nothing */; j++) {
|
||||
if (reg_table[i].ldn[j].ldn == EOT)
|
||||
break;
|
||||
|
||||
printf("%s %s\n", vendor, reg_table[i].name);
|
||||
nodump = 0;
|
||||
|
||||
if (reg_table[i].ldn[j].ldn != NOLDN) {
|
||||
printf("Switching to LDN 0x%02x\n",
|
||||
reg_table[i].ldn[j].ldn);
|
||||
|
@ -91,6 +92,9 @@ void dump_superio(const char *name, const struct superio_registers reg_table[],
|
|||
}
|
||||
printf("\n");
|
||||
}
|
||||
|
||||
if (nodump)
|
||||
printf("No dump for %s %s\n", vendor, reg_table[i].name);
|
||||
}
|
||||
}
|
||||
|
||||
|
|
|
@ -54,14 +54,18 @@ struct superio_registers {
|
|||
uint8_t regval(uint16_t port, uint8_t reg);
|
||||
void regwrite(uint16_t port, uint8_t reg, uint8_t val);
|
||||
void dump_superio(const char *name, const struct superio_registers reg_table[],
|
||||
uint16_t port, uint16_t id);
|
||||
uint16_t port, uint16_t id);
|
||||
void probe_superio(uint16_t port);
|
||||
|
||||
/* fintek.c */
|
||||
void enter_conf_mode_fintek(uint16_t port);
|
||||
void exit_conf_mode_fintek(uint16_t port);
|
||||
void dump_fintek(uint16_t port, uint16_t did);
|
||||
void probe_idregs_fintek(uint16_t port);
|
||||
|
||||
/* ite.c */
|
||||
void enter_conf_mode_ite(uint16_t port);
|
||||
void exit_conf_mode_ite(uint16_t port);
|
||||
void dump_ite(uint16_t port, uint16_t id);
|
||||
void probe_idregs_ite(uint16_t port);
|
||||
|
||||
|
@ -70,6 +74,8 @@ void dump_ns8374(uint16_t port);
|
|||
void probe_idregs_simple(uint16_t port);
|
||||
|
||||
/* smsc.c */
|
||||
void enter_conf_mode_smsc(uint16_t port);
|
||||
void exit_conf_mode_smsc(uint16_t port);
|
||||
void dump_smsc(uint16_t port, uint16_t id);
|
||||
void probe_idregs_smsc(uint16_t port);
|
||||
|
||||
|
|
Loading…
Reference in New Issue