mb/google/kahlee/liara/devicetree: move Raydium touchscreen to baseboard
Move the Raydium touchscreen to the baseboard devicetree. Since only the liara variant uses a level IRQ as I2C devices are supposed to, all other board variants still override this to use an edge IRQ which were added as a workaround to make the touchscreen work on the other devices. Right now it's unclear to me if that edge IRQ workaround was only needed temporarily and can now be removed, so I'll keep it as it was for now. If this turns out to be no longer needed on the other variants, the overrides can be dropped in the future. Signed-off-by: Felix Held <felix-coreboot@felixheld.de> Change-Id: Ic621c1a5856e9e280a25b0668010a1ee5bbb61e4 Reviewed-on: https://review.coreboot.org/c/coreboot/+/68770 Reviewed-by: Matt DeVillier <matt.devillier@amd.corp-partner.google.com> Tested-by: build bot (Jenkins) <no-reply@coreboot.org> Reviewed-by: Paul Menzel <paulepanter@mailbox.org>
This commit is contained in:
parent
771806da49
commit
6990cb29ab
|
@ -84,6 +84,18 @@ chip soc/amd/stoneyridge
|
|||
end
|
||||
end
|
||||
device ref i2c_3 on
|
||||
chip drivers/i2c/generic
|
||||
register "hid" = ""RAYD0001""
|
||||
register "desc" = ""Raydium Touchscreen""
|
||||
register "probed" = "1"
|
||||
register "irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPIO_11)"
|
||||
register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_85)"
|
||||
register "reset_delay_ms" = "20"
|
||||
register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_76)"
|
||||
register "enable_delay_ms" = "1"
|
||||
register "has_power_resource" = "1"
|
||||
device i2c 39 on end
|
||||
end
|
||||
chip drivers/i2c/generic
|
||||
register "hid" = ""ELAN0001""
|
||||
register "desc" = ""ELAN Touchscreen""
|
||||
|
|
|
@ -50,18 +50,4 @@ chip soc/amd/stoneyridge
|
|||
device i2c 2c on end
|
||||
end
|
||||
end
|
||||
device ref i2c_3 on
|
||||
chip drivers/i2c/generic
|
||||
register "hid" = ""RAYD0001""
|
||||
register "desc" = ""Raydium Touchscreen""
|
||||
register "probed" = "1"
|
||||
register "irq_gpio" = "ACPI_GPIO_IRQ_LEVEL_LOW(GPIO_11)"
|
||||
register "reset_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_85)"
|
||||
register "reset_delay_ms" = "20"
|
||||
register "enable_gpio" = "ACPI_GPIO_OUTPUT_ACTIVE_HIGH(GPIO_76)"
|
||||
register "enable_delay_ms" = "1"
|
||||
register "has_power_resource" = "1"
|
||||
device i2c 39 on end
|
||||
end
|
||||
end
|
||||
end #chip soc/amd/stoneyridge
|
||||
|
|
Loading…
Reference in New Issue