coreboot-kgpe-d16/util/intelmetool/me_status.c

193 lines
6.3 KiB
C

/* SPDX-License-Identifier: GPL-2.0-only */
#include <stdio.h>
#include <commonlib/bsd/helpers.h>
#include "me.h"
/* HFS1[3:0] Current Working State Values */
static const char *me_cws_values[] = {
[ME_HFS_CWS_RESET] = "Reset",
[ME_HFS_CWS_INIT] = "Initializing",
[ME_HFS_CWS_REC] = "Recovery",
[ME_HFS_CWS_TEST] = "Test",
[ME_HFS_CWS_DISABLED] = "Disabled",
[ME_HFS_CWS_NORMAL] = "Normal",
[ME_HFS_CWS_WAIT] = "Platform Disable Wait",
[ME_HFS_CWS_TRANS] = "OP State Transition",
[ME_HFS_CWS_INVALID] = "Invalid CPU Plugged In"
};
/* HFS1[8:6] Current Operation State Values */
static const char *me_opstate_values[] = {
[ME_HFS_STATE_PREBOOT] = "Preboot",
[ME_HFS_STATE_M0_UMA] = "M0 with UMA",
[ME_HFS_STATE_M3] = "M3 without UMA",
[ME_HFS_STATE_M0] = "M0 without UMA",
[ME_HFS_STATE_BRINGUP] = "Bring up",
[ME_HFS_STATE_ERROR] = "M0 without UMA but with error"
};
/* HFS[19:16] Current Operation Mode Values */
static const char *me_opmode_values[] = {
[ME_HFS_MODE_NORMAL] = "Normal",
[ME_HFS_MODE_DEBUG] = "Debug",
[ME_HFS_MODE_DIS] = "Soft Temporary Disable",
[ME_HFS_MODE_OVER_JMPR] = "Security Override via Jumper",
[ME_HFS_MODE_OVER_MEI] = "Security Override via MEI Message"
};
/* HFS[15:12] Error Code Values */
static const char *me_error_values[] = {
[ME_HFS_ERROR_NONE] = "No Error",
[ME_HFS_ERROR_UNCAT] = "Uncategorized Failure",
[ME_HFS_ERROR_DISABLED] = "Disabled",
[ME_HFS_ERROR_IMAGE] = "Image Failure",
[ME_HFS_ERROR_DEBUG] = "Debug Failure"
};
/* GMES[31:28] ME Progress Code */
static const char *me_progress_values[] = {
[ME_GMES_PHASE_ROM] = "ROM Phase",
[ME_GMES_PHASE_BUP] = "BUP Phase",
[ME_GMES_PHASE_UKERNEL] = "uKernel Phase",
[ME_GMES_PHASE_POLICY] = "Policy Module",
[ME_GMES_PHASE_MODULE] = "Module Loading",
[ME_GMES_PHASE_UNKNOWN] = "Unknown",
[ME_GMES_PHASE_HOST] = "Host Communication"
};
/* GMES[27:24] Power Management Event */
static const char *me_pmevent_values[] = {
[0x00] = "Clean Moff->Mx wake",
[0x01] = "Moff->Mx wake after an error",
[0x02] = "Clean global reset",
[0x03] = "Global reset after an error",
[0x04] = "Clean Intel ME reset",
[0x05] = "Intel ME reset due to exception",
[0x06] = "Pseudo-global reset",
[0x07] = "S0/M0->Sx/M3",
[0x08] = "Sx/M3->S0/M0",
[0x09] = "Non-power cycle reset",
[0x0a] = "Power cycle reset through M3",
[0x0b] = "Power cycle reset through Moff",
[0x0c] = "Sx/Mx->Sx/Moff"
};
/* Progress Code 0 states */
static const char *me_progress_rom_values[] = {
[0x00] = "BEGIN",
[0x06] = "DISABLE"
};
/* Progress Code 1 states */
static const char *me_progress_bup_values[] = {
[0x00] = "Initialization starts",
[0x01] = "Disable the host wake event",
[0x04] = "Flow determination start process",
[0x08] = "Error reading/matching the VSCC table in the descriptor",
[0x0a] = "Check to see if straps say ME DISABLED",
[0x0b] = "Timeout waiting for PWROK",
[0x0d] = "Possibly handle BUP manufacturing override strap",
[0x11] = "Bringup in M3",
[0x12] = "Bringup in M0",
[0x13] = "Flow detection error",
[0x15] = "M3 clock switching error",
[0x18] = "M3 kernel load",
[0x1c] = "T34 missing - cannot program ICC",
[0x1f] = "Waiting for DID BIOS message",
[0x20] = "Waiting for DID BIOS message failure",
[0x21] = "DID reported an error",
[0x22] = "Enabling UMA",
[0x23] = "Enabling UMA error",
[0x24] = "Sending DID Ack to BIOS",
[0x25] = "Sending DID Ack to BIOS error",
[0x26] = "Switching clocks in M0",
[0x27] = "Switching clocks in M0 error",
[0x28] = "ME in temp disable",
[0x32] = "M0 kernel load",
};
/* Progress Code 3 states */
static const char *me_progress_policy_values[] = {
[0x00] = "Entery into Policy Module",
[0x03] = "Received S3 entry",
[0x04] = "Received S4 entry",
[0x05] = "Received S5 entry",
[0x06] = "Received UPD entry",
[0x07] = "Received PCR entry",
[0x08] = "Received NPCR entry",
[0x09] = "Received host wake",
[0x0a] = "Received AC<>DC switch",
[0x0b] = "Received DRAM Init Done",
[0x0c] = "VSCC Data not found for flash device",
[0x0d] = "VSCC Table is not valid",
[0x0e] = "Flash Partition Boundary is outside address space",
[0x0f] = "ME cannot access the chipset descriptor region",
[0x10] = "Required VSCC values for flash parts do not match",
};
void intel_me_status(uint32_t hfs, uint32_t gmes)
{
/* Check Current States */
printf("ME: FW Partition Table : %s\n",
((hfs & 0x20) >> 5) ? "BAD" : "OK");
printf("ME: Bringup Loader Failure : %s\n",
((hfs & 0x400) >> 10) ? "YES" : "NO");
printf("ME: Firmware Init Complete : %s\n",
((hfs & 0x200) >> 9) ? "YES" : "NO");
printf("ME: Manufacturing Mode : %s\n",
((hfs & 0x10) >> 4) ? "YES" : "NO");
printf("ME: Boot Options Present : %s\n",
((hfs & 0x1000000) >> 24) ? "YES" : "NO");
printf("ME: Update In Progress : %s\n",
((hfs & 0x800) >> 11) ? "YES" : "NO");
printf("ME: Current Working State : %s\n",
me_cws_values[hfs & 0xf]);
printf("ME: Current Operation State : %s\n",
me_opstate_values[(hfs & 0x1c0) >> 6]);
printf("ME: Current Operation Mode : %s\n",
me_opmode_values[(hfs & 0xf0000) >> 16]);
printf("ME: Error Code : %s\n",
me_error_values[(hfs & 0xf000) >> 12]);
printf("ME: Progress Phase : %s\n",
me_progress_values[(gmes & 0xf0000000) >> 28]);
printf("ME: Power Management Event : %s\n",
me_pmevent_values[(gmes & 0xf000000) >> 24]);
printf("ME: Progress Phase State : ");
switch ((gmes & 0xf0000000) >> 28) {
case ME_GMES_PHASE_ROM: /* ROM Phase */
printf("%s", me_progress_rom_values[(gmes & 0xff0000) >> 16]);
break;
case ME_GMES_PHASE_BUP: /* Bringup Phase */
if ((gmes & 0xff0000) >> 16 < ARRAY_SIZE(me_progress_bup_values)
&& me_progress_bup_values[(gmes & 0xff0000) >> 16])
printf("%s",
me_progress_bup_values[(gmes & 0xff0000) >> 16]);
else
printf("0x%02x", (gmes & 0xff0000) >> 16);
break;
case ME_GMES_PHASE_POLICY: /* Policy Module Phase */
if ((gmes & 0xff0000) >> 16 < ARRAY_SIZE(me_progress_policy_values)
&& me_progress_policy_values[(gmes & 0xff0000) >> 16])
printf("%s",
me_progress_policy_values[(gmes & 0xff0000) >> 16]);
else
printf("0x%02x", (gmes & 0xff0000) >> 16);
break;
case ME_GMES_PHASE_HOST: /* Host Communication Phase */
if (!((gmes & 0xff0000) >> 16))
printf("Host communication established");
else
printf("0x%02x", (gmes & 0xff0000) >> 16);
break;
default:
printf("Unknown 0x%02x", (gmes & 0xff0000) >> 16);
}
printf("\n");
}