src/soc: Fix typo

Change-Id: I8053d0f0863aa4d93692487f1ca802195c2d475f
Signed-off-by: Elyes HAOUAS <ehaouas@noos.fr>
Reviewed-on: https://review.coreboot.org/27908
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Martin Roth <martinroth@google.com>

src/soc/intel/cannonlake/chip.h

@@ -156,7 +156,7 @@ struct soc_intel_cannonlake_config {
 
 	/* PCIe Root Ports */
 	uint8_t PcieRpEnable[CONFIG_MAX_ROOT_PORTS];
-	/* PCIe ouput clocks type to Pcie devices.
+	/* PCIe output clocks type to Pcie devices.
 	 * 0-23: PCH rootport, 0x70: LAN, 0x80: unspecified but in use,
 	 * 0xFF: not used */
 	uint8_t PcieClkSrcUsage[CONFIG_MAX_ROOT_PORTS];

src/soc/intel/skylake/chip.h

@@ -116,7 +116,7 @@ struct soc_intel_skylake_config {
 	/* Estimated maximum platform power in Watts */
 	u16 psys_pmax;
 
-	/* Wether to ignore VT-d support of the SKU */
+	/* Whether to ignore VT-d support of the SKU */
 	int ignore_vtd;
 
 	/*

src/soc/nvidia/tegra124/chip.h

@@ -88,7 +88,7 @@ struct soc_nvidia_tegra124_config {
 
 	int pixel_clock;
 
-	/* The minimum link configuraton settings */
+	/* The minimum link configuration settings */
 	u32 lane_count;
 	u32 enhanced_framing;
 	u32 link_bw;

src/soc/nvidia/tegra124/sdram_lp0.c

@@ -23,7 +23,7 @@
 #include <stdlib.h>
 
 /*
- * This function reads SDRAM parameters (and a few CLK_RST regsiter values) from
+ * This function reads SDRAM parameters (and a few CLK_RST register values) from
  * the common BCT format and writes them into PMC scratch registers (where the
  * BootROM expects them on LP0 resume). Since those store the same values in a
  * different format, we follow a "translation table" taken from Nvidia's U-Boot

src/soc/nvidia/tegra210/chip.h

@@ -76,7 +76,7 @@ struct soc_nvidia_tegra210_config {
 		int hpd_plug_min_us;
 		int hpd_irq_min_us;
 
-		/* The minimum link configuraton settings */
+		/* The minimum link configuration settings */
 		u32 lane_count;
 		u32 enhanced_framing;
 		u32 link_bw;

src/soc/qualcomm/ipq806x/uart.c

@@ -329,7 +329,7 @@ void uart_init(int idx)
 		GSBI_PROTOCOL_CODE_I2C_UART << GSBI_CTRL_REG_PROTOCOL_CODE_S);
 	write32(MSM_BOOT_UART_DM_CSR(dm_base), UART_DM_CLK_RX_TX_BIT_RATE);
 
-	/* Intialize UART_DM */
+	/* Initialize UART_DM */
 	msm_boot_uart_dm_init(dm_base);
 }
 

src/soc/rockchip/rk3288/clock.c

@@ -469,7 +469,7 @@ void rkclk_configure_i2s(unsigned int hz)
 
 	/* i2s source clock: gpll
 	   i2s0_outclk_sel: clk_i2s
-	   i2s0_clk_sel: divider ouput from fraction
+	   i2s0_clk_sel: divider output from fraction
 	   i2s0_pll_div_con: 0*/
 	write32(&cru_ptr->cru_clksel_con[4],
 		RK_CLRSETBITS(1 << 15 | 1 << 12 | 3 << 8 | 0x7f << 0,

src/soc/rockchip/rk3399/clock.c

@@ -804,7 +804,7 @@ void rkclk_configure_i2s(unsigned int hz)
 	int v;
 
 	/**
-	 * clk_i2s0_sel: divider ouput from fraction
+	 * clk_i2s0_sel: divider output from fraction
 	 * clk_i2s0_pll_sel source clock: cpll
 	 * clk_i2s0_div_con: 1 (div+1)
 	 */