With the memory controller the separate sockets becomes a useless
distinction. They all used the same code anyway.
UNTESTED: This also updates autoport.
Change-Id: I044d434a5b8fca75db9eb193c7ffc60f3c78212b
Signed-off-by: Arthur Heymans <arthur@aheymans.xyz>
Reviewed-on: https://review.coreboot.org/c/31031
Reviewed-by: HAOUAS Elyes <ehaouas@noos.fr>
Reviewed-by: Tristan Corrick <tristan@corrick.kiwi>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Tested with GRUB 2.02 as a payload, booting Arch Linux as
well as Debian. This code is based on the output of autoport
as well as other mainboards supported in coreboot already.
Working:
- Serial port I/O
- S3 suspend/resume. Untested with SeaBIOS since it failed
to resume on a similar board. It is likely to be due to
low memory corruption, but I have not worked on it.
- USB ports and headers
- USB3 ports attached to the ASM1042 controller. SeaBIOS can
boot from them, and it is likely GRUB can detect devices on
those ports as well. The chip has a small SPI flash nearby,
which seems to hold an Option ROM.
- Gigabit Ethernet
- Integrated graphics (libgfxinit)
- VGA BIOS for integrated graphics init
- PCIe x16 graphics
- PCIe x1
- SATA controller
- Hardware Monitor
- Fan Control (fancontrol on linux works well)
- Native raminit
- flashrom, using the internal programmer. Tested with coreboot,
as well as with the vendor firmware.
- NVRAM settings. Only debug_level has been tested.
Untested:
- DVI port. It can detect a "fake" display, that is, an
EEPROM connected to the DVI port. Thus, gma-mainboard.ads
has been setup accordingly.
- PS/2 port.
- Audio: Only rear output (green) has been tested.
- EHCI debug.
- Parallel port header.
- Non-Linux OSes
- ACPI thermal zone and fan control (probably not working)
Not working:
- Booting from devices attached to the ASM1061 controller.
Devices on ports work fine once Linux has loaded.
- Any SATA devices with Tianocore (payload issue)
Change-Id: I7e89ebe43a2e1ff0308f4876e98bbf2f5a0d85f2
Signed-off-by: Angel Pons <th3fanbus@gmail.com>
Reviewed-on: https://review.coreboot.org/26419
Reviewed-by: Nico Huber <nico.h@gmx.de>
Reviewed-by: Paul Menzel <paulepanter@users.sourceforge.net>
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
